Speciality Surface Sealer

COLOURS AVAILABLE

Clear

PRODUCT DETAIL

Appearance: Clear/Matt.
Spreading Rate: 3 – 6 m²/litre dependent on surface texture and porosity.
Solids: ± 6%
Density: ± 0,80 kg/litre.
Recommended Dry Film Thickness: Not applicable.
Viscosity: Thin liquid.
Flash Point: 43°C.

Storage:

• Keep containers properly sealed.
• Store away from direct heat, sun and severe cold in a place with adequate ventilation.

Available Sizes: 1Lt, 5Lt, 20Lt
Colours: Clear.

Respecting The Environment:

• 100% Lead Free.
• Dispose of excess product and containers in a responsible manner without harming the environment.
• This product is manufactured under strict SABS ISO 9001 quality standards.

TECHNICAL DATASHEET

Features

• Sheds off liquid water and eliminates absorption.
• Reduction of efflorescence.
• Impedance of fungal growth.
• Protects joints from decay.
• Prevent staining of stone and brick work.
• 100% lead free.

Intended Usages

• A moisture barrier sealer used on unpainted bricks, concrete, stone, fibre cement, cinder block and other masonry materials.

Application Details

• Mixing: Not applicable.
• Method: Roller, brush or spray.
• Thinning: Not required.
• Cleaning: Remove as much of the product as possible from the application equipment before cleaning with ProGold Mineral Turpentine.

Conditions:

• Temperature between 5°C and 40°C.
• Relative humidity of less than 85%, preferably between 10: 00 and 16: 00.

Drying time:
4 hours.
Note:  Higher temperatures will accelerate the drying times (approximately halved for every 10°C increase), whilst lower temperatures will retard the drying time (approximately doubled for every 10°C decrease).

Recoating time: 24 hours at 23°C with a substrate moisture contents of 15% or below.

Requirements: 2-4 coats depending on the porosity of the surface.

Surface Preparations

• Remove all dirt, loose material, grime, moss and fungus.
• Repair any defective brickwork.
• Leave new cement plaster to cure for 28 days before application.

Limitations

• Cannot be overcoated.
• Application to wet areas can lead to damp forming on the interior of that specific wall.
• Annual maintenance coats may be required.
• Not for use on walkways.

Safety

• Keep out of reach of children.
• Ensure to maintain good ventilation during application and drying process.
• In case of skin contact, wash with soap and water or a recognised skin cleaner. Avoid contact with eyes. In case of contact with eyes rinse immediately with running water and seek medical advice.
• If product is ingested drink plenty of water or milk. Do not induce vomiting at any time. Seek medical advice.
• Refer to the Material Safety Data Sheet (MSDS) for detailed information about the product and transportation and classification criteria. MSDS is available on www.prominentpaints.co.za or from Prominent Customer Service Department.
• To avoid any risk of spillage, always transport in a secure upright position.

PRODUCT SAFETY

• Keep out of reach of children.
• Ensure to maintain good ventilation during application and drying process.
• In case of skin contact, wash with soap and water or a recognised skin cleaner. Avoid contact with eyes. In case of contact with eyes rinse immediately with running water and seek medical advice.
• If product is ingested drink plenty of water or milk. Do not induce vomiting at any time. Seek medical advice.
• Refer to the Material Safety Data Sheet (MSDS) for detailed information about the product and transportation and classification criteria. MSDS is available on www.prominentpaints.co.za or from Prominent Customer Service Department.
• To avoid any risk of spillage, always transport in a secure upright position.